Six-head ductless heat pump installation in Tucson
Six indoor heads. Sized room by room.
The homeowner wanted to move from gas to electric and said the old central air had never worked right. We replaced the central system with three ductless heat pump systems and six wall-mounted indoor heads.

Actual photo from the job · July 2026
What we did
From room measurements to recorded checks
01
Size each room.
Our comfort advisor ran a room-by-room Manual J load calculation for this two-story Tucson home. Each indoor head was matched to a measured room load. We also made a pre-measure visit before installation.
02
Install the ductless systems.
We removed the old five-ton split system and installed three outdoor units and six indoor heads. The work included new refrigerant line sets in covered exterior runs, condensate drains and dedicated electrical circuits with weatherproof disconnects.
03
Check the finished work.
We recorded system operating readings. A separate quality-control visit completed the full 12-item checklist, and the equipment warranties were registered.
The plan and the finished work
See the room-load report, the planned line-set and power runs, and the finished work.
Actual photos from the job





Inspected. Passed on the first try.
All three final inspections — building, mechanical and electrical — passed on the first try, in one visit.
Considering ductless for your home? Read about ductless mini-split installation and the money-back guarantee for qualifying residential, owner-occupied installations.
Thinking about going ductless?
Read the money-back guarantee terms for qualifying residential, owner-occupied installations.

